The image below shows a Faby machine :
Step 1 – Pull the safety pin out
Step 2 – pull tap handle out
Step 3 – plunger and spring should come out, if not, use securing pin to just push it out through the bottom and the plunger and spring should come out.
Step 4 – Clean plunger and seals
Taking tank out for clean
Step 1 – The containers are unclipped from the front, just need to push up from the bottom of container and it will come off clip.
Step 2 – Give the container a “wiggle” left and right using a twisting motion and it should come off the back seal.
Step 3 – Once container is out, there will be a grey seal inside the tank as pictured below, take it out and give it a clean and clean the whole container.
Step 5 – Take the rear black seal out and clean
Step 6 – Pour warm water into the trays under tanks as shown to clear out blocked pipes
Step 7 – Take filter out which is on the left side of machine and clean thoroughly as this gets very dusty and can stop machine from freezing. Weekly clean.
Step 8 – Now put back together –
Filter back in
Rear black seal back on
Now we need to put the tap back on, plunger needs to be slightly greased using a food grade grease and the 2 white seals should be put securely on the plunger to ensure no leaks. The Spring goes on top of plunger, push plunger back in from bottom with the hole on plunger facing toward you so you can put the handle in and ensure its in place by inserting the securing pin.
Here are some pictures to help you: